Samsung F-AR12FSSSCWK1 User Manual

Contents

English-51InSTaLLaTIOn07Installing and connecting the drain hose of the indoor unitThe drain hose must NOTslant upwards.The end of the drain hosemust NOT be placed underwater.Keep a clearance of at least5 cm between the end of thedrain hose and the ground.When installing the drain hose for the indoor unit, check if condensation draining is adequate.When passing the drain hose through the 65 mm hole drilled in the wall, check the followings:Drain hose installation1. If necessary, connect the 2 meter extension drain hose to the drain hose.2. If you use the extension drain hose, insulate the inside of the extension drain hose with a shield.3. Fit the drain hose into 1 of 2 drain hose holes, then fix the end of the drain hose tightly with a clamp.4. When extending the Drain Hose, hold the end of Drain Hose and Extended Hose,rotate and insert the drain hose into Extended hose for 40~45 mm. Make sure thetwo hoses are firmly connected, there is no water leakage.5. Connect the Drain Hose after using Foam Insulation to wrap the Extended Hose. Then, Use vinyl tape to wrap theeach side of connection by 20 mm .• If you do not use the other drain hose hole,block it with a rubber stopper.Drain hose holeAfter completing theinstallation of the drainhose, pour water intothe drain pan to checkwhether the hose is welldrained.WallIndoor unitDrain hoseThe drain hose must notbe bent.5cmlessDo not place the end of thedrain hose in a hollow.Ditch• Don’t tie drain hose to the assembly pipe which may lead to water leakage.• If the diameter of the connection hose is smaller than the product's drain hose, water leakage may occur.2) Incorrect connectionPipeDrain hose1) Correct connectionPipeDrain hoseA3050 Australia_IB&IM_DB68-05206A_EN.indd 51 2014/12/29 19:07:41