Samsung HLN4365W1 Instruction Manual

Also see for HLN437W - 43" Rear Projection TV: Manual Instruction manual Instruction manual Instruction manual Instruction manual

Contents

Your New Wide TV10• For replacement, you will need a 5.91 Inches-long Phillips screwdriver and a pair of gloves.Replacing the Lamp• Why do I need to replace the lamp?The lamp used in a projection TV has a limited lifespan. For the best screen quality it needs to bereplaced periodically.After replacing the lamp, the screen quality will be bright and clear as new.• When do I need to replace it?It should be replaced when the screen becomes darker, less clear or when all three LEDs on the front(Timer, Lamp, & Temp.) are flashing.• Check before lamp replacement1. The lamp must be the same code number and type.2. The lamp type is indicated on the right side of the TV. It is also indicated on the lamp case.3. After checking the code number for the lamp, give the code number to the store where youpurchased the TV or to a Samsung Service center.• Caution1. Replace with the correct code numbered lamp to avoid damage to the TV.2. Turn the power off and wait for 30 minutes before replacing the lamp as it will be hot.3. Do not touch the glass part of the lamp with your bare hands nor insert any foreign object insidethe cover as it may cause poor screen quality, electric shock or fire.4. Do not place the old lamp near flammable objects or within the reach of children.… HLN437W1/HLN507W1HLN617W1/HLN4365W1HLN5065W1… HLN467W1/HLN567W1… HLN437W1/HLN507W1HLN617W1/HLN4365W1HLN5065W1… HLN467W1/HLN567W1NOTES• Be sure the replacement Lamp is the same type.• After replacing the lamp, align the lamp cover with the groove and secure the screw.• The TV will not turn on if the lamp cover is not correctly closed (as this will activate theprotective circuit).1 Unplug TV, then use ascrewdriver to remove thescrew as shown in thepicture.(HLN467W1/HLN567W1:Remove the rubber capand unscrew the screw.)2 Remove the Lamp cover.(HLN467W1/HLN567W1:Exert a bit of force to theright and pull for easyopening.)3 Use a screwdriver toremove the screwssecuring the Lamp. Thereare 2 screws: one on theleft and one on the right.When the screws havebeen completelyunfastened, they will stillbe connected to the bodyof the Lamp.4 Separate the Lamp fromthe engine by holding thehandle and pulling it out.5 To reinstall the Lamp,follow these steps inreverse order.11