English - 11Installing Batteries in the Remote Control1 Lift the cover at the back of the remote control upward as shown in the figure.2 Install two AAA size batteries.➢ ● Make sure to match the “+” and “–” ends of the batteries with the diagram inside thecompartment.● Do not mix battery types, i.e. alkaline and manganese.3 Close the cover as shown in the figure.➢ Remove the batteries and store them in a cool and dry place if you won’t be using the remotecontrol for a long time. The remote control can be used up to about 23 feet from the TV.(Assuming typical TV usage, the batteries last for about one year.)➢ If the remote control doesn’t work! Check the following1. Is the TV power on?2. Are the plus and minus ends of the batteries reversed?3. Are the batteries drained?4. Is there a power cut, or is the power cord unplugged?5. Is there a special fluorescent light or a neon sign nearby?ConnectionsConnecting VHF and UHF AntennasIf your antenna has a set of leads that look like this, see “Antennas with 300 Ω Flat TwinLeads” below.If your antenna has one lead that looks like this, see “Antennas with 75 Ω Round Leads”.If you have two antennas, see “Separate VHF and UHF Antennas”.Antennas with 300 Ω Flat Twin LeadsIf you are using an off-air antenna (such as a roof antenna or “rabbit ears”) that has 300 Ω twin flat leads, follow thedirections below.1 Place the wires from the twin leads under the screws on a 300-75 Ω adapter (not supplied).Use a screwdriver to tighten the screws.2 Plug the adaptor into the ANT 1 IN (CABLE) or ANT 2 IN (AIR) terminal on the rear of the TV.Antennas with 75 Ω Round Leads1 Plug the antenna lead into the ANT 1 IN (CABLE) or ANT 2 IN (AIR) terminal on the rear of theTV.Separate VHF and UHF AntennasIf you have two separate antennas for your TV (one VHF and one UHF), you must combine the two antenna signals beforeconnecting the antennas to the TV. This procedure requires an optional combiner-adaptor (available at most electronicsshops).1 Connect both antenna leads to the combiner.2 Plug the combiner into the ANT 1 IN (CABLE) or ANT 2 IN (AIR) terminal on the bottom of therear panel.
