Samsung HLT6156WX Owner's Instructions Manual

Also see for HL-T6156W: Manual Owner's instructions

Contents

English - 22Setting Up Your Remote ControlAfter your remote control has been properly set up, your remote control can operate in five different modes: TV, VCR, Cable,DVD, or Set-Top Box. Pressing the corresponding button on the remote control allows you to switch among these modes,and control whichever piece of equipment you choose.➢ The remote control might not be compatible with all DVD Players, VCRs, Cable boxes, and Set-Top Boxes.Setting Up the Remote to Operate Your VCR1 Turn off your VCR.2 Press the VCR button on your TV’s remote control.3 Press the SET button on your TV’s remote control.4 Using the number buttons on your remote control, enter three digits of the VCR code listedon page 24 of this manual for your brand of VCR. Make sure you enter three digits of thecode, even if the first digit is a “0”. (If more than one code is listed, try the first one.)5 Press the POWER button on the remote control. Your VCR should turn on if your remote isset up correctly.If your VCR does not turn on after set-up, repeat steps 2, 3 and 4, but try one of the othercodes listed for your brand of VCR. If no other codes are listed, try each VCR code, 000through 080.Note on Using Remote Control Modes: VCRWhen your remote control is in VCR mode, the volume buttons still control your TV’s volume.Continued...Storing Channels in Memory (Automatic Method)3 Press the ▲ or ▼ button to select Auto Program, then press the ENTER button.4 Press the ◄ or ► button to select an antenna connection, then press the ENTER button.➢ Air: “Air” antenna signal.Cable: “Cable” antenna signal.Air+Cable: “Air” and “Cable” antenna signals.➢ If the antenna is connected to ANT 1 IN (CABLE), select Cable and if it is connected toANT 2 IN (AIR), select Air.➢ If both ANT 1 IN (CABLE) and ANT 2 IN (AIR) are connected, select the Air+Cable.➢ If you selected Air, then go to step 6.5 Press the ◄ or ► to select the correct analog signal source among STD, HRC, and IRC,then press the ENTER button. If you have Digital cable, select the signal source for bothAnalog and Digital.➢ STD, HRC, and IRC identify various types of cable TV systems.Contact your local cable company to identify the type of cable system that exists inyour particular area. At this point the signal source has been selected.6 The TV begins memorizing all available stations.When pressing the ENTER button during a storing process, the message Would you liketo stop the auto channel selection? is displayed. Select Yes by pressing the ◄ or ►button.Press the EXIT button to exit.➢ The TV must be connected to an antenna/cable in order to receive digital TV signals.Even if a particular channel is deleted from the memory, you can always tune to thatchannel directly by using the number buttons on the remote control.➢ All available DTV and analog channels are automatically stored in memory.It takes approximately 3 to 10 minutes to memorize channels.Auto ProgramSelect the antennas to memorizeAir Cable Air+CableEnter ReturnAuto ProgramAuto Program in Progress. Cable 310%StopEnter ReturnAuto ProgramSelects the cable system.AnalogDigital STD HRC IRCSTD HRC IRCEnter ReturnAuto ProgramWould you like to stop the auto channelselection?Cable 310%Yes NoEnter Return