Samsung HP-S6373 Owner's Instructions Manual

Also see for HPS6373 - 63" Plasma TV: Manual

Contents

English-41Using Your TV as a Computer (PC) DisplaySetting Up Your PC Software (Based on Windows XP)The Windows display-settings for a typical computer are shown below. The actual screens on your PC will probably be different,depending upon your particular version of Windows and your particular video card. However, even if your actual screens look different,the same basic set-up information will apply in almost all cases. (If not, contact your computer manufacturer or Samsung Dealer.)1. First, click on “Control Panel” on the Windows start menu.2. When the control panel window appears, click on “Appearance and Themes” and adisplay dialog-box will appear.3. When the control panel window appears, click on “Display” and a display dialog-boxwill appear.4. Navigate to the “Settings” tab on the display dialog-box.The correct size setting (resolution)Optimum: 1024 x 768 pixelsIf a vertical-frequency option exists on your display settings dialog box,the correct value is “60” or “60 Hz”. Otherwise, just click “OK” and exit the dialog box.Display ModesIf the signal from the system equals the standard signal mode, the screen is adjusted automatically. If the signal from the system doesn’t equal the standard signal mode, adjust themode by referring to your videocard user guide; otherwise there may be no video. For the display modes listed below, the screen image has been optimized during manufacture.PC Display➢ • The PC text quality of HP-S6373 is optimum in WXGA mode (1360 x 768@60Hz).(Three pixels on left, right, top and bottom will be grayed out at the resolution setting of 1360x768@60Hz. This is not a mechanical problem but a result causedby the pixel difference between the standard resolution and the PDP panel.)• When this TV is used as a PC display, 32-bit color is supported.• Depending on the manufacturer, your PC display screen might appear different. (and depending on your particular version of Windows.)Check your PC instruction book for information about connecting your PC to a TV.• If a vertical and horizontal frequency-select mode exists, select 60Hz (vertical) and 48.4kHz (horizontal).• In some cases, abnormal signals (such as stripes) might appear on the TV screen when the PC power is turned off (or if the PC is disconnected). If so, press theSOURCE button on the remote control or SOURCE button on the side panel to enter a VIDEO mode. Also, make sure that the PC is connected.• The interlace mode is not supported.• The TV operates abnormally if a non-standard video format is selected.• The table above conforms to IBM/VESA regulations and is based on using the Analog Input.• “✔” mark means that this mode can be supported.Video SignalIBM PC / ATCompatibleResolution(Dot X Line)VerticalFrequency (Hz)640 X 350720 X 400640 X 480800 X 6001024 X 7681280 X 7201360 X 76870.08670.08759.94070.00072.80975.00056.25060.31770.00072.18875.00060.00470.06972.00075.02959.85560.015HorizontalFrequency (KHz)31.46931.46931.46935.00037.86137.50035.15637.87943.75048.07746.87548.36356.47657.67260.02344.77247.712VerticalPolarityNPNN/PNNN/PPN/PPPNNN/PPPPHorizontalPolarityPNNN/PNNN/PPN/PPPNNN/PPNPHP-S6373✔✔✔✔✔✔✔✔✔✔✔✔✔✔✔✔✔