Samsung HT-DM550 Instruction Manual

Also see for HT-DM550: Manual Instruction manual Instruction manual Instruction manual Instruction manual

Contents

CONNECTIONS14FM antenna connection1. Connect the FM antenna supplied to the FM 75COAXIAL terminal as temporary measure.2. Slowly move the antenna wire around until youfind a location where reception is good, thenfasten it to a wall or other rigid surface.• If reception is poor, connect an outdoor antenna.Before attaching a 75 coaxial cable (with a standardtype connector), disconnect the supplied FM antenna.AM(MW/LW) antenna connection1. Connect the AM loop antenna suppliedto the AM and terminals.2. If reception is poor, connect an outdoorsingle vinyl-covered wire to the AMterminal. (Keep the AM loop antennaconnected).Connecting the FM and AM(MW/LW) Antennas13A cooling fan is mounted on the rear panel of the center unit toprevent abnormal temperature inside the center unit, thus assuringnormal operation. The cooling fan automatically starts rotating tosupply external cool air to the inside of the center unit when theinternal temperature exceeds the specified limit.For safety, observe the following carefully.• Make sure there is good ventilation around the center unit. Poorventilation could overheat and cause damage.• DO NOT block the cooling fan and the ventilation openings orholes. (If they are blocked by a newspaper or cloth, etc., the heatmay not be able to escape.)Snap the tabs on the loop into theslots of the base to assemble theAM loop antenna.Cooling fan (See “About Cooling Fan” below.)ANTENNA1 2 3If FM reception is poor,connect an outdoor FM antenna(not supplied).FM Antenna (supplied)AM Loop Antenna(supplied)If AM reception ispoor, connect anoutdoor AMantenna(notsupplied).AUX ConnectionsLRDIGITAL OUTVIDEO OUTVIDEO INExternal DigitalComponentsExternal AnalogComponentsAudio Cable (Red/White)If the external analogcomponent has only oneoutput jack, you may connecteither L or R.For connection to externalequipment with digital output.Example: CD recorders, MD (Mini Disc) D/Aconverters or other components equippedwith digital output jacksConnect to external equipment withanalog output.Example: Video, TV, etc.• Always connect the video andaudio connection cables to theequivalent colored jack.Press AUX on the remote control to select DIGITAL IN, AUX1, or AUX2.Press Function on the main unit to select DIGITAL IN, AUX1, or AUX2.• Each time the button is pressed the mode switches as follows: FM AM DVD DIGITAL IN AUX 1 AUX 2.To Play External Digital/Analog EquipmentOptical Cable(not supplied)Video CableTo view pictures fromexternal input (AUX 1 ,AUX 2 ), first connect theVIDEO IN jack (AUX 1 ,AUX 2 ) and then connectthe VIDEO OUT jack.TV(About the cooling fan)