Samsung IDCS 28D User Manual

Also see for IDCS 14B STRIP: User guide User guide User instructions User guide

RECALL DIAL TONEPress the NEW button to disconnect your existing call, wait for dial tone andthen make a new call on the same line.NOTE: If this button does not appear on your keyset, the FLASH key maybe programmed to recall dial tone.SENDING A FLASHWhile on an outside call, press the FLASH key to send a flash to the tele-phone company. This is required for some custom calling features or CEN-TREX use.NOTE: Flash is not available on an ISDN circuit.BUSY LINE QUEUING WITH CALLBACKIf you receive a busy signal when you are selecting an outside line, thismeans that the line or group of lines is busy.• Press the CBK key, if programmed, or dial 44. You will hear confirmationtone.• When the line becomes free, the system will call you back.• Lift the handset or press the ANS/RLS key to answer, wait for dial toneand dial the telephone number or speed dial number again.NOTES:1. A callback will be canceled if not answered within 30 seconds. If youhave set a callback, your CBK key will light.2. If the Hot Keypad feature has been turned off, you must first lift the hand-set or press the SPEAKER key before dialing.CANCELING CALLBACKA callback will be canceled if not answered within 30 seconds. If you haveset a callback, your CBK key will light.Your phone may have a maximum of five callbacks to lines and/or stationsset at a time. To cancel a callback:• Press the CBK key, if programmed, or dial 44. You will hear confirmationtone.• While you are listening to confirmation tone, press the HOLD key. Thiswill cancel the oldest set callback.NOTES:1. If the hot keypad feature is turned off, you must first lift the handset orpress the SPEAKER key before dialing.15 16INTERCOM CALLSCALLING OTHER STATIONS• Dial the extension number or group number.• Wait for the party to answer. If you hear a brief tone burst instead of ring-back tone, the station you called is set for Voice Announce or AutoAnswer. Begin speaking immediately after the tone.• Finish the call by replacing the handset or pressing the ANS/RLS key.NOTES:1. If you have a DSS key assigned to an extension or station group, youmay press this key instead of dialing the number.2. If the Hot Keypad feature has been turned off, you must first lift the hand-set or press the SPEAKER key before you begin dialing.ANSWERING INTERCOM CALLS• When your keyset rings, simply lift the handset—OR—press theANS/RLS key to be connected to the calling station.• Finish the call by replacing the handset or pressing the ANS/RLS key.See Ring Preference under Customizing Your Keyset.VOICE ANNOUNCE MODEWhen another station calls you, your keyset will sound a brief attention toneand you will hear the caller’s announcement.• Press ANS/RLS to turn on the microphone and speak handsfree—OR—lift the handset to reply.• To finish the call, replace the handset or press the ANS/RLS key.Note: In order for C.O. calls to be answered handsfree, AUTO ANS CO mustbe set to ON.AUTO ANSWER MODEWhen another station calls you, your keyset will sound a brief attentiontone and then automatically answer the call.• Your microphone and speaker are turned on and you can speak hands-free. For privacy, use the handset.• To finish the call, replace the handset or press the ANS/RLS key.Note: In order for C.O. calls to be answered handsfree, AUTO ANS CO mustbe set to ON.