Section 2I: Using Voice Recognition 112Using Send Text With a single voice command you can launch the text message clienton the phone and specify a recipient for the message.To launch a text message:1. Press and hold .2. Say “Send Text” followed immediately by the name of a personin your contact list and, optionally, the type of the number youwant to send it to. For example, say “Send Text John Smith.”If you do not specify the number type and there are multiplenumbers for the name, VoiceSignal chooses the mobile number bydefault.If you say the “Send” command without specifying a recipient,VoiceSignal prompts you with “Say the name.” Say the name of aperson in your contact list and, optionally the type of number.Using Lookup You can look up and display contact information for any personstored in your contact list by saying “Lookup,” followed by the name.To use Lookup :1. Press and hold .2. Say “Lookup John Smith.” The IP-A790 Contacts application forthe specified contact is displayed.If you say only “Lookup,” VoiceSignal prompts you with “Say thename.”
