Samsung LN52A550 User Manual

Also see for LN32A550: Manual Quick setup guide User manual User manual

Contents

Setting Up Anynet+The following settings help set the Anynet + functions.To use the Anynet+ Function, Anynet + (NDMI-CEC) must be set to On1. Press the MENU button. Press the A or T button to select "Application",then press the ENTER O# button.2, Press the A or T button to select "Anynet + (HDMI-CEC)", then press theENTER C_ button.3. Press the ENTER C_ button to select "Anynet + (HDMI-CEC)".4, Press the A or T button to select "On", then press the ENTER C_ button.>- The "Anynet + (HDMI-CEC)" function is enabled."_ If you select Off, "Anynet ÷ (HDMI-CEC)" is disabled.>- When the "Anynet ÷ (HDMI-CEC)" function is disabled, all the Anynet +related operations are deactivated.Setting an Anynet + Device to turn Off Automatically when the TV is Turned Off12.Press the A or T button to select "Auto Turn Off', then press the ENTERbutton.Press the A or V' button to select "Yes", then press the ENTER _ button.>- The "Auto Turn Off" function is enabled."_ If you select "No", the "Auto Turn Off" function is canceled.Press the EXIT button to exit.The active source on the TV remote must be set to TV to use the Anynet +function.If you set "Auto Turn Off" to "Yes", connected external devices are also turnedoff when the TV is turned off. If an external device is still recording, it may ormay not turn off.Scanning and Switching between Anynet + Devices1. Press the TOOLS button.Press the A or T button to select "Device List", then press the ENTER _ button.>- Anynet+ devices connected to the TV are listed."_ If you cannot find a device you want, press the red button to scan for devices.1 Press the A or _' button to select to a particular device and press the ENTER O#button. It is switched to the selected device.>- Only when you set "Anynet ÷ (HDMI-CEC)" to On in the "Application" menu, the"Device List" menu appears.>- Switching to the selected devices may take up to 2 minutes. You cannot cancel the operation during the switchingoperation."_ The time required to scan for devices is determined by the number of connected devices.>- When the device scan is complete, the number of devices found are not displayed.>- Although the TV automatically scans devices when it is turned on using the POWER button, devices connected whenthe TV is already on are not displayed in the device list. In this case, select the Searching Connections menu to searchdevices.If you have selected external input mode by pressing the SOURCE button, you cannot use the Anynet+ function. Makesure to switch to an Anynet+ device by using the TOOLS button.