172. Using a network-connected machineInstalling driver over the network 6Windows1 Make sure that the machine is connected to the network andpowered on. Also, your machine’s IP address should havebeen set (see "Setting IP address" on page 13).If the “Found New Hardware Wizard” appears during theinstallation procedure, click Cancel to close the window.2 Insert the supplied software CD into your CD-ROM drive.The software CD should automatically run and an installationwindow will appear.3 Select Install Now.When you click the Advanced Installation, you can use theCustom Installation option. The Custom Installationallows you to select the machine’s connection and chooseindividual components to install. Follow the instructions onthe window.4 Read License Agreement, and select I accept the terms ofthe License Agreement. Then, click Next.The program searches for the machine.If your machine is not found on the network or locally, anerror message appears.• Check if you want to install the software withoutconnection of the printer.- Check this option to install this program without amachine connected. In this case, the print a test pagewindow will be skipped, and completes the installation.• Search againWhen you press this button, the firewall notice windowappears.- Turn off the firewall and Search again. For Windowsoperating system, click Start > Control Panel >Windows Firewall, and inactivate this option.- Turn off the firewall from the third party's programbeside the operating system. Refer to the manualprovided by individual programs.
