Samsung MagicLAN SWL-2000N User Manual

Contents

55Table A. MagicLAN Packet Driver Parameter ValuesParameter DescriptionESSID Alphanumeric string with a maximum of 10 ASCIIcharacters that identifies the network to which you wouldlike to connect your computer.Note that this string is NOT case-sensitive.NETWORKMODE MagicLAN can be used in 'Ad-Hoc' mode where AccessPoint (AP) is not required or in 'Infrastructure' mode whereall communication will be made through an AP.Available values are as follows:0 : Ad-Hoc mode1 : Infrastructure modeCHANNEL This parameter is used as an operating channel.The domain and its available channel are shown in TableB.INTEROP Interoperability Flag. If this parameter set to '1',MAGICLAN can be used with other wireless LAN cardsthat based on IEEE 802.11 specification and supportinteroperability. Otherwise MAGICLAN can communicateonly with MAGICLAN LAN card.IRQ Interrupt Request Number. If you use PnP (Plug and Play)bios, you can leave this parameter unspecified.Available values are as follows:PCMCIA cards : 2 to FIO This parameter is used as an I/O base port forMAGICLAN. If you use PnP (Plug and Play) bios, you canleave this parameter unspecified.Available values are as follows:200, 240, 280, 2C0, 300, 340, 380MEM This parameter is used as a memory base address segmentfor MAGICLAN. If you use PnP (Plug and Play) bios, youcan leave this parameter unspecified.Available values are as follows:C800, D000, D800