141 Click My Network Place> View networkconnections on the Desktop. Right-click over Wireless Network Connection andselect Disable.A2 The On LAN> function is configured sothat it is supported in Standby mode (S3). To usethis function in Hibernation mode (S4) or in theTurn Off (S5) state, configure it as follows: Enter BIOS SETUP and select the Boot menu. Move to the Wake On Lan item and press the Enterkey. Change it from Disabled to Enabled and pressthe Enter key.QWhen I connected 100Mbps wired LAN andthe computer exits standby/hibernate mode,a message informing 10Mbps wired LANconnection appears.A When the computer exits standby/hibernatemode, restoring the network takes about 3seconds. When the network is restored, itoperates in 100Mbps.QI cannot find an AP.▶ Check the Wireless LAN LED.A Check if the Wireless LAN LED is on. If off, pressthe Wireless LAN On/Off button + toturn it on.▶ Reinstall the driver.A Reinstall the driver using the software media.▶ Check the Wireless Zero Configuration (WZC) service.A If the “Windows cannot make this wirelessconnection” message appears while searchingfor wireless networks, it indicates that a programother than Windows is set to manage the wirelessLAN settings.▶ To use the wireless LAN settings using Windows:A Click Start > Control Panel > Network andInternet Connections > Network Connections> Wireless LAN Connection, right-click andcheck if the “Windows manages wireless networksettings (W)” option is selected in the WirelessNetwork tab of the Properties window. If not,select the option.Wireless LAN Related
