Troubleshooting 97Q7 When using a computer-to-computer (Ad Hoc) network, sometimes I cannotsearch the access point.A It may happen occasionally when you are using a computer-to-computer (AdHoc) network connection. Even if you cannot find some access points, thecomputer-to-computer (Ad Hoc) network is operating properly. Click Refresh toview the latest search result.Q8 Running Help file while running Profile Wizard in the wireless LANprogram (PROSet) makes the PROSet window white.A It will be displayed properly when you finish the profile wizard. It dose not affectthe program operation.Q9 The network does not operate properly when both the wireless and the wirednetwork connections are simultaneously configured with the same IPaddress.A You cannot use the wireless and the wired network connections using the sameIP address simultaneously. To use either the wireless or the wired network in turnwith the same IP address, you have to Disable whichever network device will notbe using in the network connection of the Control Panel.Q10 The wireless LAN does not operate properly when there are other productsoperating in the 2.4GHz band.A1 Since IEEE 802.11b and IEEE 802.11g equipment uses a common frequency orthe ISM band, channel interference may occur when a wireless video transceiveror a microwave oven is being used. If you experience channel interference fromother equipment, it is recommended changing the channel to connect to the AP.A2 IEEE802.11g equipment operates in hybrid mode when there is activeIEEE802.11b equipment. This may result in data rate degradation.Q11 An established wireless LAN connection is disconnected after 2~3 minutes,and the connection is not recovered.A1 This may be caused by channel interference. Change the channel of the AP, andreconnect.A2 This may be caused by selecting the ’Use IEEE 802.1x network authentication’option when IEEE 802.1x authentication is not available.
