Samsung QL 6100 User Manual

Also see for QwikLaser 6100: User manual

Contents

4. 9PrintingCONFIGUse this tab to control the following printer features:• Power Save determines the length of time the printer waits after a jobis printed before it goes to a reduced power state. If the printer is usedfrequently, select OFF which keeps the printer ready to print with theminimum warm-up time. This uses more electricity to keep the printerwarm and ready to print.• Econo Mode determines the toner quantity the printer should usewhen printing. If set to ON, the printer conserves toner when printing.The default value is OFF, which provides 100% usage.• Auto Continue determines what action the printer should take when amanual feed print job is sent to the printer and there is no paper in theMP Tray. If set to ON, the printer will pick up the paper from cassetteafter fifteen seconds. Otherwise, the printer will wait for you to loadpaper in the MP Tray.• Jam Recovery determines what action the printer should take when apaper jam occurs. When set to OFF, the printer does not reprint a pagethat has jammed. When set to ON, the printer keeps the image inmemory for a printed page until the printer signals that the page hassuccessfully printed. The printer reprints all jammed pages.• Altitude helps the printer optimize its output depending on the airpressure of the region. If you are close to sea level, it should be set to“Low.” If at a high elevation (1,500 m / 5,000 ft or higher), set it to“High.”JOBUse this tab to control the following printer features:• Timeout determines the amount of time (in seconds) the printer willwait before printing the last page of a print job that does not end with acommand to print the page or a formfeed character. Valid range is 0 to300 seconds.• Paper Type provides the printer with information about the type ofpaper to be used for a print job. If you use paper with a weight of morethan 42 lb. (90 g/m2), or an envelope, set this to Thick and use the MPTray’s manual feed slot. Otherwise use the Normal setting.• Toner Density determines the overall density of the printed image.Valid selections are Light, Medium and Dark.• Image Quality mode makes the printer optimize the print quality to1200 dpi image quality.