Setting Up _9sEtting uP tHE REFRigERatoRNow that you have your new Refrigerator installed and in place, you are ready to set up and enjoy the features andfunctions of the appliance.By completing the following steps, your Refrigerator should be fully operational.1. Place the Refrigerator in an appropriate locationwith reasonable clearance between the wall andthe Refrigerator. Refer to installation instructions inthis manual.2. Once the Refrigerator is plugged in, make sure theinterior light comes on when you open the doors.3. Set the Temperature control to the coldesttemperature and wait for an hour. The Freezer willget slightly chilled and the motor will run smoothly.4. After powering the Refrigerator, it will take a fewhours to reach the appropriate temperature. Youcan store food and drinks in the Refrigerator oncethe temperature is sufficiently cool.01 sEtting uPREMoVing tHE REFRigERatoR DooRsIf your entrance won’t allow the Refrigerator to pass easilythrough it, you can remove the doors.Disassemble the Refrigerator doors1. With the door closed, remove the top table( 1 )using a Philips screwdriver, and then disconnect thewires( 2 ). Remove hinge screws( 3 ) and groundscrew( 4 )21342. Lift the door straight up to remove.3. With a Philips head screwdriver, remove the twoscrews( 10 ) attached to the lower left and rightdoor hinges.With an Allen Wrench(3/16”), remove the two hexhead bolts( 11 ) attached to the lower left and rightdoor hinges.Remove the lower left and right door hinges( 12 ).tools you will need101211Philips screwdriver 10mm Socket Wrench Allen wrench(3/16”)Flat-blade screwdriver PliersCheck the accessory list below.Water filter(DA29-00003B)Hex wrench(DA80-00002C)Compressionfitting(DA62-00305A)Compressionnut(DA74-00070B)Fastener(DA60-00143B)Washer(DA80-00002C)