Samsung RF32FMQDBSR User Manual

Also see for Refrigerator: Owner's manual User manual User manual User manual Owner's instructions

14_ setting upHOW TO ADJUST THE DOOR GAPIf the gap between the left and right fridgecompartment doors is not even.• You can adjust the gap by turningthe bolt at the top right of the coldstorage compartment door.• Do not turn the bolt too far.You can break it.1. With the doors closed, remove the 3 screwsholding the top cover using a Phillipsscrewdriver, and then lift it off together with theconnected cables.2. Turn the bolt with a 4 mmhexagonal L-wrench to adjustthe gap. (Not provided)3. Turn the bolt clockwise to( ) widen the gap.Turn the bolt counter clockwise ( ) to narrowthe gap.INSTALLING THE WATERDISPENSER LINEA water dispenser with a filter is one of the helpfulfeatures on your new refrigerator. To help promotebetter health, the water filter removes unwantedparticles from your water. However, it does notsterilize or destroy microorganisms. You may needto purchase a water purifying system to do that.The water line also connects to the ice maker.For the ice maker to operate properly, waterpressure of 20~125 psi (138~862 kPa) is required.If the refrigerator is installed in an area with lowwater pressure (below 20 psi), you can install abooster pump to compensate for the low pressure.After you have connected the water line, makesure the water storage tank inside the refrigerator isproperly filled. To do this, press the water dispenserlever until the water runs from the water outlet.• Water line installation kits are available atextra cost from your dealer.We recommend using a water lineinstallation kit that contains coppertubing and ¼” compression nut.Connecting to the water supply line1. First, shut off the main watersupply.2. Locate the nearest cold water drinking line andinstall the pipe clamp and shut off valve.Pipe clampCold water lineShut off valve3. Connect the water line installation kit to the shutoff valve.Shut off valvePipe clampCold water lineWater line installation kitConnecting the water supply line to therefrigerator.There are several items that you need to purchaseto complete this connection.You may find these items sold as a kit at your localhardware store.For Copper Tubing For Plastic Tubing• ¼” copper tubing• ¼” compression nut (1pc)• Ferrule (2pc)• ¼” plastic tubing→ Molded end(Bulb)• ¼” compression nut (1pc)DA68-02918A-01.indb 14 13. 4. 25. �� 2:30