18_ Setting UpSetting up your French Door RefrigeratorCHECKinG tHE watER DisPEnsER LinEA water dispenser is one of the helpful features on your new refrigerator. To help promote betterhealth, the water filter removes unwanted particles from your water. However, it does not sterilize ordestroy microorganisms. You may need to purchase a water purifying system to do that.In order for the ice maker to operate properly, a water pressure of 20~125 psi is required.Under normal conditions, a 170 cc (5.75 oz.) cup can be filled in 10 seconds.If the refrigerator is installed in an area with low water pressure (below 20psi), you can install a booster pump tocompensate for the low pressure.Make sure the water storage tank inside the refrigerator is properly filled. To do this, press the water dispenserlever until the water runs from the water outlet.Shut off valvePipe clampCold water lineWater line installation kitWater line installation kits are available at extra cost from your dealer. We recommend using a water lineinstallation kit that contains copper tubing and ¼” compression nut.After connecting the water supply with water filter, turn on water supply and Flush 3 gallons through filterbefore use (flush approximately 6 minutes).If water drop or leakage is found on the connection area, turn off the main water supply.Check it and, if necessary, tighten it more.Pipe clampCold water lineShut off valve2. Locate the nearest cold water drinking line and install the pipeclamp and shut off valve.3. Connect the water line installation kit to shut off valve.1. First, shut off the main water supply.Connecting to the water supply line