setting up _0701 SETTING UPSlot32. Disconnect one connector ( 3 ) on the right sidedoor and one connector ( 4 ) on left side door. Toremove the water coupler from the hinge, twist andpull it from the hinge. Remove the water line ( 5 )while pressing the marked part ( 6 ) of the water linecoupler.If a red clip is on the coupler, it must beremoved before removing the tube.3. Pull and remove the hinge lever ( 7 ). Remove theground screw ( 8 ) attached to the upper left andright door hinges with a philips screwdriver (+).Remove the upper left and right door hinges ( 9 ).4. Lift the door straight up to remove.CAUTIONAllen wrenchAllen wrench1210114563Red ClipRed Clip(1/4")(1/4")7 8912125. Remove the screw ( 10 ) attached to the lower leftand right door hinges with a philips screwdriver (+).Remove the 2 hex head bolts ( 11 ) attached tothe lower left and right door hinges with an allenwrench (3/16”). Remove the lower left and rightdoor hinges ( 12 ).REATTACHING THEREFRIGERATOR DOORSTo reattach the fridge doors after you have moved thefridge to its fi nal location, assemble parts in reverseorder.DISASSEMBLE THE FREEZERDRAWER1. Take out the upper drawerby lifting it up.2. Remove the tilting pocket( 1 ) by pulling both supportguards ( 2 ) upward at thesame time.3. Take out the lower basket( 3 ) by lifting the basket upfrom the rail system.4. Remove 4 hex head boltsfrom both sides with a socketwrench (10mm).5. Lift up the freezer door fromthe rails.