Samsung RFG296HD User Manual

Also see for RFG296HD SERIES: Quick start guide User manual User manual User manual User manual

08_ setting upASSEMBLE THE FREEZER DRAWERTo reattach the drawer after you have moved thefridge to its fi nal location, assemble parts in reverseorder.ADJUSTING THE LEVELMake sure the refrigerator is level so that you canmake final adjustments. Use a level to test if therefrigerator is level both side to side and back to front.If the refrigerator is not level, it will not be possibleto get the doors perfectly even, which may causemoisture condensation and increased energy bills.Below is an example of how to level the refrigerator ifthe left side of the refrigerator is lower than the rightside.How to adjust the level1. Open the freezer drawerand remove the lowerbasket. (See to page 7)2. Remove the two screws( 1 ) attached to the coverleg front ( 2 ) with a Philipsscrewdriver (+).3. Remove the cover leg front( 2 ) by lifting the bottompart of the cover leg frontup and pulling it out.4. Insert a fl at-blade screwdriver (-) into a notch on theleft control lever, and turn it count clockwise to levelthe refrigerator. (You turn the lever clockwise to lowerthe refrigerator and counterclockwise to raise it.)Both control levers must be touching the floorto avoid possible personal injury or propertydamage because of tipping.If the right side is lower, perform the sameprocedure, but with the right control lever.It is diffi cult to remove the cover leg front from therefrigerator, so we do not recommend makingsmall adjustments with the control lever. Instead,refer to the next page for the best way to makeminor adjustments to the doors.MAKING MINOR ADJUSTMENTSBETWEEN DOORSRemember, a leveled refrigerator is necessary forgetting the doors perfectly even. If you need help,review the previous section on leveling the refrigerator.The left door is fi xed. To make minor adjustmentsbetween doors, adjust only the right door.1. Pull out the freezer drawer ( 1 ), then you can seethe lower hinge ( 2 ).2. Insert the supplied allen wrench(3/16”) ( 3 ) into theshaft ( 4 ) of the lower hinge.3. Please adjust the height by turning the hex wrench( 3 ) clockwise ( DOWNDOWN ) or counter-clockwise ( UPUP ).When you turn the hex wrench counter-clockwise( ), the door will move up.1. After adjusting the doors, insert the suppliedfastener ( 6 ) using a pliers ( 5 ) in the gap betweenthe hinge-grommet ( 7 ) and the lower hinge( 8 ). The number of fasteners you’ll need to insertdepends on the gap.2 fastener are enclosed with the refrigerator.The thickness of each fastener is 0.04”.flat-blade screwdriver(-)flat-blade screwdriver(-) Control LeverControl Lever31234AdjustmentAdjustmentpartpartFixed partFixed partCAUTION21