Samsung RS2511 Series Service Manual

Also see for RS2511 series: Owner's manual and installation

Samsung RS2511 Series Service Manual Manual pdf 30 page image

52. INSTALLATION1) To protect refrigerator in movementUse padded hand truck as shown. If entrance width isless than 39〃, remove doors prior to installation andreattach doors according to procedure below.2) Remove all protective tape and pad in refrigerators.Connect water lines and power cord. Adjust theclearance between the doors.3) Set the temperature control to the temperature andwait for an hour.The refrigerator should get slightly chilled and the motorruns smoothly.4) Once the refrigerator temperature is sufficiently lowYou can store food in the refrigerator. After starting therefrigerator, it takes a few hours to reach the appropriatetemperature.●● Removing Doors(Freezer)Open the freezer and refrigerator doors, andthen take off the front leg cover assembly byunlocking the hook(upper side:3EA, lower side:3EA) of the front leg.With the door closed, remove the upper hingecover using a screwdriver, and then disconnectthe wires. Remove hinge screws and groundscrew counter-clockwise, and take off the upperhinge. Take care removing the door to ensure thatit does not fall on you.Remove the door from the lower hinge bycarefully lifting the door so as not to damage thewater tube.●● Attaching Doors-Freezer : Attach the freezer door by insertingthe hose in the lower side of the door into the holein the lower hinge and pulling the hose down.-Refrigerator : Insert the lower hinge in thebracket lower hinge. Attach the door to thecabinet.Insert the upper hinge shaft into the hole. Afterleveling between the upper hinge hole and thehole of the cabinet. Reattach hinge screws andscrew in the clockwise direction. Connect thewires. Put the front part of the upper hinge coveron the front part of the upper hinge(➀) andreattach from the front part of the upper hingecover first(➁).