English - 2101 SETTING UPRe-attaching the Water Supply Lines1. The Water Lines must be fully Inserted into thecenter of the transparent coupler to preventwater leakage from the dispenser.2. Insert the 2 clips in the install pack as shownbelow, and then confirm that each clip holdsthe line firmly.Center of Transparent couplerClip A (1/4”)Make sure the color of the water linesmatch.LEVELING THE REFRIGERATORMake sure the refrigerator is level so that you canmake final adjustments.Use a level to test if the refrigerator is level bothside to side and back to front.If the refrigerator is not level, you will not be ableto get the doors perfectly even, which may causemoisture condensation and increased energy bills.The front of the refrigerator is alsoadjustable.Before levelling the refrigerator, removethe front leg cover.Open both the freezer and refrigerator doors.Unscrew the three screws holding the front legcover in place by turning them counter-clockwise.When the screws are loose, remove the front legcover.CAUTIONWhen the Freezer part is lower than theFridge part.Insert a flat-blade screwdriver into a slot on theFreezer Leg, then turn it clockwise.When the Fridge part is lower than theFreezer part.Insert a flat-blade screwdriver into a slot on theFridge Leg, then turn it clockwise.Screw Driver LegRefer to the next section for the best wayto make very minor adjustments to thedoors.DA68-02981F (EN)-150612.indd 21 2015. 6. 12. 11:20