English - 10CAUTIONWhen installing, servicing or cleaning behind therefrigerator, be sure to pull the unit straight out andpush back in straight after finishing.First things first! Make sure that you can easilymove your refrigerator to its final location bymeasuring doorways (both width and height),thresholds, ceilings, stairways, etc.The following chart details the exact height anddepth.Dimensions [inch (mm)] ModelRS25H5121** RS25H5111**Width Only Cabinet 908 (35 3/4)With Leg Front 914.4 (36)DepthOnly Cabinet 763.3 (30 1/16)With Door 875 (34 1/16)With Handle 940 (37)90° Open F 1,173 (46 2/11) /R 1,288 (50 17/24)135° Open F 1,018 (40 3/38) /R 1,109 (43 43/65)HeightOnly Cabinet 1,740 (68 1/2)With Hinge 1,760 (69 9/32)With Door 1,775 (69 7/8)• Allow clearance to the right, left, backand top when installing.This will help reduce power consumptionand keep your energy bills lower.• Make sure you disconnect the water supply lineBEFORE removing the freezer door.To avoid damage, refer to ‘Separating thewater line from the refrigerator’ in the manualSETTING UP THE REFRIGERATORNow that you have your new Refrigerator installedin place, you are ready to set up and enjoy thefeatures and functions of the appliance.By completing the following steps, yourRefrigerator should be fully operational.If not, first check the power supply and electricitysource or try the troubleshooting section at theback of this user’s guide.If you have any further questions, contact yourSamsung Electronics service center.1. Place the Refrigerator in an appropriate locationwith reasonable clearance between the walland the Refrigerator.Refer to installation instructions in this manual.2. Once the Refrigerator is plugged in, make surethe interior light comes on when you open thedoors.3. Set the Temperature control to the coldesttemperature and wait for an hour.The Freezer will get slightly chilled and themotor will run smoothly.4. After powering the Refrigerator, it will take a fewhours to reach the appropriate temperature.You can store food and drinks in theRefrigerator after the temperature is sufficientlycool.5. Assemble the water line to the refrigerator andverify that the couplers are correctly assembledwithout water leakage.(Refer to ‘Installing the water line’, page 16)SSEDA-14 (RS25H5121) .indd 10 2013. 11. 28. 11:28