setting up _0701 SETTING uPSETTING uP ThE REFRIGERATORDOORSIf your entrance won’t allow the refrigerator to passeasily through it, you can remove the doors.Separating the Water Supply Line from theRefrigerator1. Pull the two water lines (which are in the Fixer) outto the front.2. Remove two water lines (White one is for waterand the other one is for ice) by pressing thecoupler 1 and pulling the water line 2 away.Removing the freezer doorA few things to mention first.• Make sure that you lift the door straight up so thehinges are not bent or broken.• Be careful not to pinch the water tubing and wireharness on the door.• Place doors on a protected surface to preventscratching or damage.1. With the Freezer door closed, remove the upperhinge cover 1 using a screwdriver, and thendisconnect the wires by gently pulling them apart2 .2. Removing the FIXER HINGE ,and next take off theupper hinge. Be careful that the door does not fallon you as you are removing it.Be sure to keep track of all parts you areremoving.3. Next, remove the door from the lower hinge 3 bycarefully lifting the door straight up 4 .Be careful not to pinch the water tubing andwire harness on the door.Reattaching the freezer doorsTo reattach the freezer doors, replace parts in reverseorderReattaching the Water Supply Line1. The Water Line must be fully inserted to themarked line to prevent water leakage from thedispenser.2. Insert the 2 clips in the install pack and check thateach clip holds the line firmly.Do not cut the water line. Gently separate itfrom the coupler.12Make sure the color ofthe water lines match.1243Line Linecoupler couplercoupler couplerclip A (¼”) clip A (¼”)