Samsung RSG309 SERIES User Manual

Also see for RSG309 SERIES: Quick start guide User manual User manual User manual

08_ setting upReattaching the freezer doorsTo reattach the freezer doors, replace parts in reverseorderReattaching the Water Supply Line1. The Water Line must be fully Inserted to the centerof transparent coupler to prevent water leakagefrom the dispenser.2. Insert the 2 clips in the install pack and check thateach clip holds the line firmly.Do not cut the water line. Gently separate itfrom the coupler.Removing the Fridge Door1. Remove a screw on the upper hinge cover 1 .With the door open, disengage the two lockingtabs with a flat-head screw driver 2 and removeit while the lifting up the rear of the cover 3 , andthen disconnect the wires by gently pulling themapart 4 .2. Removing the FIXER HINGE ,and next take off theupper hinge. Be careful that the door does not fallon you as you are removing it.Be sure to keep track of all parts you areremoving.3. Remove the door from thelower hinge 5 by lifting thedoor straight up 6 .Reattaching the Fridge doorTo reattach the fridge doors, replace parts inreverse order.LEVELLING THE REFRIGERATORNow that the doors are back on the refrigerator, youwant to make sure the refrigerator is level so that youcan make final adjustments. If the refrigerator is notlevel, it will not be possible to get the doors perfectlyeven.When the Freezer part is lower than the Fridgepart.Insert a flat-blade screwdriver into a slot on theFreezer Leg, then turn it clockwise.When the Fridge part is lower than the Freezerpart.Insert a flat-blade screwdriver into a slot on the FridgeLeg, then turn it clockwise.Refer to the next section for the best way tomake very minor adjustments to the doors.Freezer LegScrew DriverFridge Leg Screw Driver653241center of transparent couplerclip A (¼”)(6.35mm)DA68-02500B.indb 8 2012.6.7 1:39:59 PM