10_ setting upReattaching the Fridge Door1. Insert the lower hinge 1 back into the lowerhinge bracket 2 .2. Fit the hole in the corner of the fridge door 3over the lower hinge 4 .3. Insert the upper hinge shaft 5 into the holeon the hinge 6 . Make sure the hinge is levelbetween the upper hinge hole 7 and the hole onthe top of the cabinet 8 . Then, reattach hingescrews 9 and the ground screw 10 by turning itin a clock wise direction.4. Place the front part of the upper hinge cover 11on the front of the upper hinge 12 and reattach itwith the screw.Reattaching the Water Supply Line1. Insert the water line 1 into the coupler 2 .Reattaching the Water Supply Line1. Water line must be fully inserted to the marked lineto prevent water leakage and water dripping fromthe water dispenser.2. Insert the 2 clips in the install pack and check thateach clip holds the line fi rmly.Do not cut the water line. Gently separate itfrom the coupler.Reattaching the Front Leg CoverBefore attaching the cover, check waterconnector for leakage.Replace the front leg cover by turning the threescrews clockwise, as shown in the fi gure.1234121112Line LineCouplerCoupler CouplerCouplerCouplerCouplerclip A(6.35mm)clip A(6.35mm)CouplerCouplerWHITEWHITE WHITEWHITE GRAYGRAY GRAYGRAY