setting up _1301 SETTING UP4. After connecting the water supply to the waterfi lter, turn your main water supply back on anddispense about 1l to clear and prime the waterfi lter.Connecting the water line to therefrigerator1. Remove the dust cap from the water line on therear of the unit and fi t a compression nut from theinstall kit.2. Remove the water pipe from the install kit and fi t acompression nut to one end.3. Join the two pipes together using the compressionjoint from the install kit ensuring that the joint iswater tight.4. Join the other end of the install pipe to the mainwater supply and turn on the water to check forleaks.Only connect the water line to a drinkable watersource.If you have to repair or disassemble the waterline, cut off 6.5mm of the plastic tubing tomake sure you get a snug, leak-free connection.Before being used, the leakage inthese places should be examined• Samsung Warranty does not cover WATER LINEINSTALLATION.• The cost of connection to a water supply is at thecustomer expense, unless included in the deliverycharge (refer to the delivery agreement with theseller)• Please contact Plumber or Authorised Installer forthe installation if needed.• If Water leakage occurs due to improperinstallation, Please contact installer.INSTALLING THE WATERDISPENSER LINEFor Exterior modelParts for water line InstallationConnecting to the water supply lineConnect the water pipe with coupler and tap.1. Close the main water tap.2. Connect coupler “A” to the tap.Close MainClose MainWater pipeWater pipeClose MainClose MainWater pipeWater pipeNO GAPNO GAPWater line fi xer and screwsPipe connectorWater line Purifi er lock-clip Purifi erRemoveRemovecapcapWater LineWater Linefrom unitfrom unitWater LineWater Linefrom Kitfrom KitNo gapNo gapLoosen aLoosen aCAUTION CAUTIONThe water line must be connected to the coldwater pipe. If it is connected to the hot waterpipe, it may cause the purifi er to malfunction.