English - 18INSTALLING THE WATERDISPENSER LINEA water dispenser is one of the helpful features onyour new Samsung Refrigerator.To help promote better health, the Samsung waterfilter removes unwanted particles from your water.However, it does not sterilize or destroymicroorganisms.You may need to purchase a water purifyingsystem to do that.The water line also connects to the ice maker.For the ice maker to operate properly, waterpressure of 20 ~ 125 psi (138 ~ 862 kPa) isrequired.If the refrigerator is installed in an area with lowwater pressure (below 20 psi), you can install abooster pump to compensate for the low pressure.After you have connected the water line, makesure the water storage tank inside the refrigeratoris properly filled.To do this, press the water dispenser lever untilwater runs from the water dispenser.Water line installation kits are available atextra cost from your dealer.We recommend using a water supply kitthat contains copper tubing.Connecting to the water supply line1. First, shut off the main water supply line andturn the ice-maker off.2. Locate the nearest cold water drinking waterline.3. Install the pipe clamp and shut off valve.4. Connect the water line installation kit to theshut off valve.Shut off valvePipe clampCold water lineWater line installation kitConnecting the water supply line to therefrigeratorThere are several items that you need to purchaseto complete this connection.You may find these items sold as a kit at your localhardware store.Use Copper Tubing Use Plastic Tubing• ¼” copper tubing• ¼” compression nut(1pc)• Ferrule (2pc)• ¼” plastic tubing→ Molded end (Bulb)• ¼” compression nut(1pc)Compression Nut(1/4”) (Assembled)Ferrule(Not supplied)Plastic Tubing(Assembled)CompressionFitting (Assembled)BulbCompressionnut (B) (1/4”)(Not supplied)orCopper tubing(Not supplied)Plastic tubing (B)(Not supplied)Household water supply lineRefrigerator1. Connect the household water line to theassembled compression fitting.- If you are using copper tubing, slip thecompression nut ( B ) (not supplied) andferrule (not supplied) on the copper tubing (notsupplied) as shown.- If you are using plastic tubing ( B ), insert themolded end (Bulb) of the plastic tubing ( B ) intothe compression fitting.CAUTIONDo not use plastic tubing ( B ) without the moldedend (Bulb).DA68-02966A-00.indb 18 2013. 12. 10. �� 2:44