Samsung SCC-C4205P Owner's Instructions Manual

Also see for SCC-C4205: Owner's instructions

22E21❙ FOCUS MODEThe FOCUS MODE menu performs AF(Auto Focus),MF(Manual Focus), and ONEAF(One Auto Focus).✔ AF : Focuses automatically by continuously monitoring thescreen in AUTO FOCUS mode. It does not process theFOCUS button input because it focuses automaticallyduring ZOOM.✔ MF : You can manually adjust the focus.✔ ONEAF : Focuses about 5 seconds only when ZOOM ismoved Wide to Tele. It is same as MF mode whilein STOPmode, and same as AF mode after ZOOM Tele.CAMERA ID OFFIRIS ALC...SHUTTER OFFAGC LOWWHITE BAL ATW1FOCUS MODE AFMOTION DET OFFCOLOR/BW COLORPRIVACY OFFSPECIAL ...PRESET ...EXIT QUIT❙ MOTION DETMOTION DET detects any motion. Set up this functionduring no human movement to detect break-in. Oncedetected, an ALARM signal will be given for 5 seconds. AsMOTION DET detects any motion, so it can set up themotion detection sensitivity. Select ON... and press [ENTER]and the MOTION DET submenu screen will appear.❙ WHITE BALYou can select one of four modes for white balance adjustment asfollows:- ATW1/ATW2(Auto-Tracing White Balance Mode): In these modes,the color temperature is monitored continuously and thereby whitebalance is set automatically. The following are the approximatesupported color temperature ranges in these modes.ATW1 : 2500K ~ 9300K(✻1)ATW2 : 2000K ~ 10000K(Mode recommended for sodiumlighting)(✻2)✻ 1. If the color temperature is out of this range in ATW1 mode,proper white balance may not be obtained. In that case, selectATW2 mode.✻ 2. In ATW2 mode, if one color is dominated in the shooted area,the color can be displayed differently. Therefore, select themode which is appropriate for the environment.- AWC(Auto-Tracing White Balance Control): In this mode, accuratewhite balance is obtained by pressing [ENTER] while having awhite paper in front of the camera. White Balance data will bemaintained after set it once. AWC mode is best in locations wherethe color temperature of light source is constant.- MANU : If WHITE BAL menu is set to MANU mode, the user canset the white Balance considering the current illumination. SelectMANU item and press [ENTER], the sub screen where you canselect Manual White Balance will be shown. Use the left/right keysto select 3200K, 5600K or OFF(USER) mode in the PRESETmenu.✔ 3200K : Set color temperature to 3200K✔ 5600K : Set color temperature to 5600K✔ USER : Choose out a proper value from the RED and BLUEgraph for color and temperature setup.(MANU)PRESET OFF(USER)..RED (80) - - - - I - - - -BLUE (80) - - - - I - - - -RET