251. In Standby mode, press and hold .“Say a Command” appears in the display and ispronounced through the speaker.2. Say “Call”.VoiceSignal prompts you to “Say the name or #”.3. Speak clearly and say the telephone number of the personyou want to call. For example, say “7 8 1 5 5 5 6 2 0 0."If it recognizes the number, Voice Dial repeats and dials thenumber. If Voice Dial is not sure it has recognized thenumber, it displays a choice list of up to three numbers andprompts you with “Did you say?” followed by the firstnumber on the list.4. Say “Yes” to confirm the number or “No” to hear the nextone, or use the keypad to select the correct number fromthe list. (For more information, refer to “Choice Lists” onpage 104.)• To say the name again, press the Repeat soft key.• To exit Voice Dial without dialing, press .Pause Dialing From a Contacts Entry• If you voice dial a contact that contains (two-second) P pause(s) simplywait for the pauses to pass and the dialing to complete.• If you voice dial a contact that contains (hard) W pause(s), wait for theappropriate prompt(s) from the number you are calling (credit cardnumber, bank account number, and so on) and enter the appropriateresponse(s).Answering a CallYour phone notifies you of a call in the following ways:• A ring tone sounds and/or your phone vibrates (Your phone providesseven ring volume settings including: Silence All, Vibrate, Low,Low/Medium, Medium, Medium/High, or High, and/or differentring types to distinguish callers. You can add vibration to any ringvolume setting.)• A phone number (unless blocked by the caller) and a name display onthe screen (If the caller’s number and name are stored in your Contactslist).• If the caller can’t be identified, Call from unavailable#, Call fromrestricted number, or no number appears in the display.• Your phone continues to notify you of the call until one of the followingevents occurs:– You answer the call.– You ignore the call.– You mute the ringer.