Voice Signal (CDMA Only) 173Voice Signal (CDMA Only)Voice Signal commands give you the power to launchapplications using your voice. Simply say a command at theprompt to record memos, open the Phone Book, open thebrowser, and more.1. In standby mode, press and hold .After a brief pause, “Say a Command” appears in thedisplay and is pronounced through the speaker.2. After the phone beeps, say the name of the commandthat you wish to perform. The Voice Signal commandslisted in the following table are available.More information on the commands listed in the previoustable is available in the following sections.Command FunctionQuick DialLets you dial a person by saying the name you’verecorded for that person. Before you can use QuickDial, you’ll need to record the names that you wishto use.Digit DialL ets you dial any valid seven-digit or ten-digitphone number by speaking the number natu-rally, without pausing between digits.Voice memoRecord voice memos for later playback. You canalso record the caller on the other end of the lineduring a phone conversation.Name DialLets you dial any person in your Phone book bypronouncing that person’s name. It automaticallyvoice activates every contact in your Phone bookwithout the need to record or “train” names beforeusing them.ContactsLets you retrieve contact information for any personin your Phone Book by pronouncing the name ofthat person.Browser Opens the browser to the Verizon Wireless homepage.VerizonA790 ver.2.book Page 173 Monday, March 22, 2004 11:20 AM
