19• Press the Settings soft key, then press the Exit soft key to exitVoiceSignal without dialing.Pause Dialing From a Contacts EntryIf you voice dial a contact that contains 2-Sec Pause(s) simplywait for the pauses to pass and the dialing to complete.If you voice dial a contact that contains Wait(s), wait for theappropriate prompt(s) from the number you are calling (creditcard number, bank account number, and so on) and enter theappropriate response(s).Answering a CallIncomingWhen you receive a call, the phone displays one of the following:• If the caller can be identified, the caller’s number (or name if it’s in yourContacts) appears in the display.• If the caller cannot be identified, “Call from unavailable #”, “Callfrom restricted #”, or no number appears in the display.Tip: Assign pictures to Contacts entries. The entry’s assigned pictureappears in the display when you receive a call from that entry. (For moreinformation, refer to “Assigning a Picture to a Contacts Entry” onpage 35The phone continues to notify you of the call until one of thefollowing events occurs:• You answer the call.• The calling party ends the call.• The call is sent to voicemail.Call Notification FeaturesYour phone notifies you of a call in a variety of ways.• Eight ring volume settings: Ringer Off, Vibrate, Low, Low/Medium,Medium, Medium/High, High, or Vibrate/High.• Different ring types or melodies to distinguish callers.• Name display with caller ID. (If the caller’s name is programmed intoyour Contacts).• Information about the last 90 each of incoming, missed, and outgoingcalls are automatically stored in a Calls log.Set Call Ringer Volume1. In standby mode, press the Volume key ( ) on theleft side of the phone up or down to set the call ringervolume as desired. Options are:2. Press SET once you’re satisfied with the setting. The phonereturns to standby mode.• Ringer Off • Medium• Vibrate • Medium/High• Low • High• Low/Medium • Vibrate/High