Installation12Making a CopyCopy a document to verify proper machine operation. You can copy single or multiple pagedocuments.1 Turn the page face down and insert it into the document feeder.2 Adjust the document guide to match the width of the document.3 Feed the document into the machine. The automatic document feeder pullsin the page. If necessary, press RCV.Mode$!Contrast to choose the desiredcontrast for the document.4 Press (Copy).The display shows ‘NUMBER OF COPIES’.•If you want one copy at preset copy rate, press Copy again and skip step 5 below.•If you want two or more copies, press Start/Enter and enter the number.•If you want to change copy rate, select COPY RATE by pressing!➛!or❿ and Start/Enter. You can scale the document from 75% to 100% by entering the number, andthis change will remain on the non-volatile memory and affect every copy you aregoing to make. The default copy rate is 97%.5 Press (Start/Enter) when the number on the display is correct.Copying begins. The display shows the page number that is being copied.When the machine runs out of paper, supply additional paper and pressStart/Enter, then remaining copy will resume.