Media and tray412. Menu Overview and Basic Setup(●: Supported, Blank: Not supported)EnvelopePrinting successfully on envelopes depends upon the quality of the envelopes.To print an envelope, place it as shown in the following figure.• When selecting envelopes, consider the following factors:- Weight: should not exceed 90 g/m 2 otherwise; jams may occur.- Construction: should lie flat with less than 6 mm curl and should notcontain air.- Condition: should not be wrinkled, nicked, nor damaged.- Temperature: should resist the heat and pressure of the machineduring operation.• Use only well-constructed envelopes with sharp and well-creased folds.• Do not use stamped envelopes.• Do not use envelopes with clasps, snaps, windows, coated lining, self-adhesive seals, or other synthetic materials.• Do not use damaged or poorly made envelopes.• Be sure the seam at both ends of the envelope extends all the way to thecorner of the envelope.1 Acceptable2 Unacceptable• Envelopes with a peel-off adhesive strip or with more than one flap thatfolds over to seal must use adhesives compatible with the machine’s fusingtemperature for 0.1 second about 170°C (338 °F). The extra flaps and stripsmight cause wrinkling, creasing, or jams, and may even damage the fuser.• For the best print quality, position margins no closer than 15 mm from theedges of the envelope.• Avoid printing over the area where the envelope’s seams meet.
