101System requirementsSystem requirementsFor Windows For MacintoshPC with processor better thanPentium II 450MHz(Pentium 800MHz recommended)* Samsung ConverterPC with processor better thanPentium 500MHz (Pentium IVrecommended)Power Mac G3 or later, or IntelProcessorWindows 98SE / 2000 / ME /XP/Vista* Samsung ConverterWindows 2000 or laterrecommendedMac OS 10.1 ~ 10.4Minimum 128MB RAM(Over 512MB recommended)Minimum 256MB RAM110MB of available hard-disk spaceUSB port USB portCD-ROM drive CD-ROM drive1024×768 pixels, 16-bit colordisplay compatible monitor(24-bit color display recommended)Microsoft DirectX 9.0 or laterMPlayer (For movie clip)About the softwareAfter inserting the CD-ROM provided with this camera into theCD-ROM drive, the following window should automatically run.Before connecting the camera to the PC, youshould first install the camera driver. Camera driver: This enables images to transfer between the camera andPC.This camera uses the USB Storage Driver as the camera driver. Youcan use the camera as a USB card reader. After installing the driverand connecting this camera to the PC, you can find [Removable Disk]in [Windows Explorer] or [My computer]. A USB Storage Driver isprovided only for Windows. A USB Driver for MAC is not included with theApplication CD. You can use the camera with Mac OS 10.1~10.4. XviD codec: This makes movie clips (MPEG-4) recorded with thiscamera play back on a PC.To play back a movie clip recorded with this camera, you must install theXviD codec. If a movie clip recorded with this camera does not play well,install this codec. This software is only compatible with Windows.
