Anynet+ (HDMI-CEC)There is somethingwrong with the TV. Try this!Anynet+ does notwork.Check if the device is an Anynet+ device. The Anynet+ system supports Anynet+devices only.Only one external device may be connected to Receiver.Check if the power cord of the Anynet+ device is properly connected.Check the cable connections of the Anynet+ device.Navigate to the System menu and verify that Anynet+ (HDMI-CEC) is set to On.Check whether the TV remote control is in TV mode.Check whether the remote control is Anynet+ compatible.Anynet+ may not function under certain circumstances. (Searching channels,operating Smart Hub or Setup, etc.)If you have disconnected and then reconnected the HDMI cable, scan for devicesagain or turn your TV off and on.I want to startAnynet+.Check if the Anynet+ device is properly connected to the TV and then navigate tothe System menu to see if Anynet+ (HDMI-CEC) is set to On.After checking, press 간편메뉴 button, select Anynet+ (HDMI-CEC) and then choosea device.I want to exit Anynet+. Select View TV from the Anynet+ menu.Select a non-Anynet+ device from Source.The message"Connecting toAnynet+ device..."or "Disconnectingfrom Anynet+ device"appears on the screen.Users cannot use the remote control when you are configuring Anynet+ orswitching to a viewing mode. Use the remote control after the TV has completedthe Anynet+ configuration or has switched to a viewing mode.The Anynet+ devicewon't play. Users cannot use the play function when Setup is progress.The connected deviceis not displayed.Check whether the device supports Anynet+.Check whether the HDMI cable is properly connected.Navigate to the System menu and verify that Anynet+ (HDMI-CEC) is set to On.Scan for Anynet+ devices again.Anynet+ devices must be connected to the TV using an HDMI cable. Make sure thedevice is connected to your TV with an HDMI cable. Some HDMI cables may notsupport Anynet+.If the connection is terminated because there has been a power failure or the HDMIcable has been disconnected, please scan for the device again.The TV audio is notbeing played throughthe receiver.Connect an optical cable to the TV and the receiver.ARC enables digital sound to be output via the HDMI (ARC) port.However, ARC is only available when the TV is connected to an audio receiver thatsupports ARC.
