Samsung SP-C802R User Manual

Also see for SP-C802R: Manual

Contents

● To power ON: Press button until the unit beeps twice.● If the unit is not powered on even if you press button, place it on the charger. Later, itwill turn on automatically. Charge the unit for one day before using.● To power ON: Press and hold button in the standby state until the unit beeps.98Base set InstallationTelephoneConnectionConnect thetelephone to a220V outlet.Connect thetelephone to a220V outlet.Open thebattery lid.Put the batteryas shown in thepicture.Remote set Installation1 2 Put the batterytight to the upperpart as shown inthe picture.3 Close thebattery lid.4Placing the battery in the remote setBattery Life● We guarantee the battery life of 6 months from thepurchase.● Battery is a consumable, whose life is reduced along withtime. If the battery performance is reduced to the half theinitial performance, purchase a new battery.To purchase a new battery, contact Supply Division atSamsung Electronics Service Center.@@@@@@ÀÀÀÀÀÀHow to use battery?● Charge the remote set for more than 24 hoursbefore initial use.● If you do not use the telephone for a longtime, make it sure to separate the batteryfrom the remote set and keep it safe.To power ON/OFF the remote set● After installation, pick up the handset and make it sure that dial tone is transmitted.● If there is no dial tone, check the connections of the telephone line and the power line.● This product should be operated at 220V only.● Place the remote set on the charger and check whether CHARGE light turns on.● Press button and check whether dial tone is transmitted.● If there is no dial tone, check whether the base set has been properly installed.What is the standby state?The stadnby state refers to the state in which no call is made or answered and the unit isready for ringing.(State in which the user does not speak over the phone and the telephone is waiting foroperation.)Telephone InstallationDC 12V 500mADC 12V 500mA