Health and safety information76• Do not paint the phone. Paint can clog thedevice’s moving parts and prevent properoperation.• Do not put the phone in or on heating devices,such as a microwave oven, a stove or a radiator.The phone may explode when overheated.• Use only the supplied or an approvedreplacement antenna. Unauthorized antennas ormodified accessories may damage the phoneand violate regulations governing radio devices.• If the phone, battery, charger or any accessoryis not working properly, take it to your nearestqualified service facility. The personnel there willassist you, and if necessary, arrange for service.Acknowledging special precautionsand the FCC and industry canadanoticeCautionsModifications not expressly approved by the partyresponsible for compliance could void the user'sauthority to operate the equipment.FCC compliance informationThis device complies with Part 15 of FCC Rules.Operation is subject to the following twoconditions:(1) This device may not cause harmfulinterference.Health and safety information77(2) This device must accept any interferencereceived. Including interference that maycause undesired operation.Information to userThis equipment has been tested and found tocomply with the limits for a Class B digital device,pursuant to part 15 of the FCC Rules. These limitsare designed to provide reasonable protectionagainst harmful interference in a residentialinstallation.This equipment generates, uses and can radiateradio frequency energy and, if not installed andused in accordance with the instructions, maycause harmful interference to radiocommunications. However, there is no guaranteethat interference will not occur in a particularinstallation. If this equipment does cause harmfulinterference to radio or television reception, whichcan be determined by turning the equipment offand on, the user is encouraged to try to correctthe interference by one or more of the followingmeasures:• Reorient or relocate the receiving antenna.• Increase the separation between the equipmentand receiver.• Connect the equipment into an outlet on acircuit different from that to which the receiveris connected.• Consult the dealer or an experienced radio/ TVtechnician for help.