8 TroubleshootingHere is a brief list of the potential problems that mayarise with your device. For more information, pleasevisit us online at www.sprint.com/AIRAVE. My Power LED is not Illuminating. Make sure that one end of the power cord isplugged in to an active outlet and that the otherend is properly connected to the power supply. Make sure the power connector is securelyinserted into the rear 12 VDC port on the back ofthe base station. My GPS LED is not illuminating blue. The GPS antenna is either unable to obtain orhaving difficulty obtaining a GPS signal. Move the base station to a location with fewersurrounding obstructions. The new locationshould be in a more open area and near a closedwindow, if possible. If the preceding fails, remove the power cord fromthe wall outlet for at least 10 seconds. Make sure the power adapter is properlyconfigured and securely connected to the rear ofthe base station. Reconnect the power connector to the 12 VDCport and plug the power cord into the wall outlet.This allows the base station to re-initiate its startupsequence where it detects the Ethernetconnection, GPS signal, and communication withthe Sprint wireless network. If relocation does not produce a GPS signal,uninstall the GPS antenna from the base stationand relocate it to receive a stronger signal. My WAN LED is red and not blue. A red light indicates that the WAN port is receivingpower but has not detected a valid Ethernetconnection.Note: The first time the base station is used after installation orafter relocation, it could take up to one hour to acquire aGPS fix. This is normal.TroubleshootingSprint AIRAVE_Important_Info.book Page 8 Wednesday, February 17, 2010 7:37 AM