Samsung SV-DVD3 Instruction Manual

Also see for SV-DVD3E: Instruction manual Instruction manual Service manual Service manual

Contents

DVDDVDDVDGB51GB50If your A/V receiver is equipped with a DTS decoder, your DVD-VCR can output DTS digital sound, but you MUST enable thisfeature in the menu system.NOTE: Select “Yes” ONLY if you have connected a DTS-equippedA/V receiver to the DIGITAL AUDIO OUT (optical or coaxial) onthe DVD-VCR back panel.1 Open “MAIN MENU”With the DVD in stop mode, press the SETUP button.2 Select “DVD”Using the up/down and left/right buttons, move the selection cursorto “DVD SETUP,” then push ENTER to select.3 Select “Audio Options”Move the selection bar to “Audio Options,” then push ENTER toselect.4 Set “DTS”Move the selection bar to “DTS,” then push ➛ or ❿ to select fromthe following options:• Off - To use your DVD/TV with an A/V receiver NOT equippedwith a DTS decoder.• On – To use your DVD/TV with an A/V receiver equipped with aDTS decoder.DTSMPEG-2 Digital OutMAIN MENUDVD SETUPRETURN "❷!!➛!!!❿ ENTERProgram Clock Install ExitDVD VCR Option LanguageDVDRETURN "❷!!!!!!!!!!ENTERDVD SETUPDisc Menu EnglishAudio EnglishSubtitle AutomaticParental UnlockedAudio OptionsDisplay OptionsRETURN "❷AUDIO OPTIONSDolby Digital Output PCMMPEG-2 Digital Out ➛ ❿ PCMDTS OffDynamic Compression OnMAIN MENUDVD SETUPRETURN "❷!!➛!!!❿ ENTERProgram Clock Install ExitDVD VCR Option LanguageDVDRETURN "❷!!!!!!!!!!ENTERDVD SETUPDisc Menu EnglishAudio EnglishSubtitle AutomaticParental UnlockedAudio OptionsDisplay OptionsRETURN "❷AUDIO OPTIONSDolby Digital Output PCMMPEG-2 Digital Out PCMDTS ➛ ❿ OffDynamic Compression OnOffOnDynamic CompressionDynamic Compression constrains the dynamic range, i.e. thedifference between the quietest and loudest passages of a DVDsoundtrack. This enables you to limit loud noises, such asexplosions, or raise the volume of quiet passages, such aswhispering, while watching a movie. This is convenient for viewingmovies late at night.1 Open “MAIN MENU”With the DVD in stop mode, press the SETUP button.2 Select “DVD”Using the up/down and left/right buttons, move the selection cursorto “DVD SETUP,” then push ENTER to select.3 Select “Audio Options”Move the selection bar to “Audio Options,” then push ENTER toselect.4 Set “Dynamic Compression”Move the selection bar to “Dynamic Compression,” then pushright to select from the following options:• On - The total dynamic range of the DVD soundtrack will becompressed, so quiet passages will be louder and loudpassages will be softer.• Off – The original dynamic range will be preserved.MAIN MENUDVD SETUPRETURN "❷!!➛!!!❿ ENTERProgram Clock Install ExitDVD VCR Option LanguageDVDRETURN "❷!!!!!!!!!!ENTERDVD SETUPDisc Menu EnglishAudio EnglishSubtitle AutomaticParental UnlockedAudio OptionsDisplay OptionsIf your A/V receiver is equipped with a Dolby Digital decoder, yourDVD-VCR can output Dolby Digital 5.1 sound, but you MUSTenable this feature in the menu system to prevent damage to yourspeakers.1 Open “MAIN MENU”With the DVD in stop mode, press the SETUP button.2 Select “DVD”Using the up/down and left/right buttons, move the selection cursorto “DVD SETUP,” then push ENTER to select.3 Select “Audio Options”Move the selection bar to “Audio Options,” then press ENTER toselect.4 Set “MPEG-2 Digital Out”Move the selection bar to “MPEG-2 Digital Out” then press the rightbutton to select from the following options:• PCM - To use your DVD/TV with an A/V receiver NOT equippedwith a Dolby Digital decoder.• Bitstream – To use your DVD/TV with an A/V receiver equippedwith a Dolby Digital decoder.RETURN "❷AUDIO OPTIONSDolby Digital Output PCMMPEG-2 Digital Out PCMDTS OffDynamic Compression ➛ ❿ On OnOff