English - 26Downloading the E-Smart App andConnecting the Refrigerator to yourNetwork1. On your Smartphone, connect to the app store(e.g. Google Play, etc.).2. Search for the app using “Samsung E-SmartRef.” as the keyword.3. Download the app and install it on your phone.4. Launch the app.The network configuration screen appears.5. Configure the AP information (SSID, Password,etc.) on the app screen.6. Configure the network settings according to theinstructions in the app.7. On the refrigerator, press and hold the Fridgeand Energy Saver buttons at the same time for3 seconds.The refrigerator enters the AP mode.8. If you have completed the network settingsproperly, the app shows the home screen.• Please confirm your Internet devices (AP,Smartphone) are working properly beforeconfiguring the network settings.- This refrigerator supports the IEEE 802.11a/b/g/n protocols.Samsung Electronics recommends IEEE802.11n.- To connect the refrigerator to a wirelessnetwork, you have to connect the refrigerator toan AP (router or modem).If the AP supports DHCP, you can connect therefrigerator to the Internet using DHCP or afixed IP address.- Set the channel of the AP to one not currentlybeing used.If the channel set for the AP is being usedby another device nearby, it may result ininterference.- Most wireless networks allow you to configurenetwork security settings.If your network has a security password, youmust enter the password to connect to thenetwork.• The refrigerator supports the following wirelesssecurity modes and encryption types:- Security Mode: WEP, WPAPSK, WPA2PSK- Encryption Type: WEP, TKIP, AES(WPA2PSK and AES are recommended.)• The app supports indoor control only.• The Samsung E-Smart Ref. app is optimizedfor Samsung Electronics Smartphones (GalaxyS4, Galaxy Note 3).For other Smartphones, some functions maywork differently.• Supported Wireless Channel is 1 to 11.DA68-02976A-01.indb 26 14. 3. 4. �� 1:24