Sansui HDLCD1908 Owner's Manual

Also see for HDLCD1908: Owner's manual

Sansui HDLCD1908 Owner's Manual Manual pdf 15 page image

15 ENGLISHSetting the languageYou can choose from three different languages(English, French and Spanish) for the on-screendisplays.Select the language you prefer first, thenproceed with the other menu options.1 To turn on the TV, press POWER.(POWER indicator on the front of the unitchanges green. It may take approx. 10 secondsfor a picture to appear on screen.)2 Press MENU. The menu screen will appear.AudioChannelLockSetupMain MenuPicture >>: Select ENTER:Set3 Press or to select “Setup”, then press orENTER.4 Press or to select “Language”.Video Label >>BacklightAuto Shut Off OffReset >>16SetupClosed Caption >>Language English: Adjust: SelectNOTE:When you press MENU first time after purchase thisLCD TV, above screen will appear automatically.•5 Press or to select the desired language:English, French (Français) or Spanish (Español).6 Press EXIT to return to the normal screen.NOTE:If no buttons are pressed for more than about 60seconds, the menu screen will return to normaloperation automatically.Memorizing channelsThis TV is equipped with a channel memoryfeature which allows channels to skip up or downto the next channel set into memory, skippingover unwanted channels. Before selectingchannels, they must be programmed into theTV’s memory. To use this TV with an antenna, setthe Signal Type option to the Air mode. Whenshipped from the factory, this menu option is inthe Cable mode.Air/Cable selection1 Press MENU. The menu screen will appear.2 Press or to select “Channel”, then pressor ENTER.3 Press or to select “Auto Ch Memory”, thenpress or ENTER.4 Press or to select “Signal Type”.5 Press or to select “Air” or “Cable”.•Air - VHF/UHF channelsCable - CABLE TV channelsAutomatic Search StartAuto Ch MemorySignal Type Cable: Adjust: Select6 Press EXIT to return to the normal screen.CABLE CHARTThe chart below is typical of many cable systemchannel allocations.NOTE:It may take a few seconds for a digital channelpicture to appear on screen after being selected.Automatic search1 Press MENU. The menu screen will appear.2 Press or to select “Channel”, then pressor ENTER.3 Press or to select “Auto Ch Memory”, thenpress or ENTER.4 Press or to select “Automatic Search”,then press or ENTER.Auto Ch MemorySignal Type CableDigital Channel Found : 0Analog Channel Found : 0: Select ENTER:CancelAutomatic Search Stop5 The TV will begin memorizing all the channelsavailable in your area.It may take from 15 minutes to 30 minutes tocomplete memorizing digital cable channels.Depending on the reception condition, a bardisplay may not advance for several minutes,please be patient.•NOTE:Memorizing channels is best accomplished duringevening “PRIMETIME” hours, as more stations arebroadcasting digital signals. Memorizing channelscan only be accomplished while a station isbroadcasting a digital signal to set that channel intomemory.If you are unsure of the digital channels availablein your area, you may visit www.antennaweb.org toreceive a list based on your address or zip code.Should you require further assistance you may callour toll-free customer service line at 1-800-289-0980.New digital channels may be added to your areaperiodically, it is recommended to perform the“Automatic Search” procedure regularly.••••Downloaded from www.Manualslib.com manuals search engine