Sansui HDLCD1908 Owner's Manual

Also see for HDLCD1908: Owner's manual

Sansui HDLCD1908 Owner's Manual Manual pdf 3 page image

3ENGLISHIMPORTANT SAFETY INSTRUCTIONS1) Read these instructions.2) Keep these instructions.3) Heed all warnings.4) Follow all applicable instructions.5) Do not use this apparatus near water.6) Clean only with a clean dry cloth.7) Do not block any ventilation openings. Install in accordance with the manufacturer's instructions.8) Do not install near any heat sources such as radiators, heat registers, stoves, or other apparatus (includingamplifiers) that produce heat.9) Do not defeat the safety purpose of the polarized or grounding-type plug. A polarized plug has two bladeswith one wider than the other. A grounding type plug has two blades and a third grounding prong. Thewide blade and the third prong are provided for your safety. If the provided plug does not fit into your outlet,consult an electrician to replace the obsolete receptacle.10) Protect the power cord from being walked on or pinched particularly at plug, and the point where it exitsfrom the apparatus.11) Only use attachments/accessories specified by the manufacturer.12) Use only a cart, stand, tripod, bracket, or table designed to support the weightand size of the unit. When a cart is used, use caution when moving the cart/apparatus combination to avoid injury from tip-over.13) Unplug this apparatus during lightning storms or when unused for long periods oftime.14) Refer all servicing to qualified service personnel. Servicing is required when theapparatus has been damaged in any way, such as power-supply cord or plugdamage, liquid has been spilled or objects have fallen into the apparatus, theapparatus has been exposed to rain or moisture, does not operate normally, orhas been dropped.15) Apparatus should not be exposed to dripping or splashing, and objects filled with liquids, such as vases,should not be placed on the apparatus.16) An outside antenna system should not be located in the vicinity of overhead power lines or other electriclight or power circuits, or where it can fall into such power lines or circuits. When installing an outsideantenna system, extreme care should be taken to keep from touching such power lines or circuits, ascontact with them might be fatal.17) Do not overload wall outlets and extension cords, as this can result in a risk of fire or electric shock.18) Do not push objects through any openings in this unit, as they may touch dangerous voltage points or shortout parts that could result in fire or electric shock. Never spill or spray any type of liquid into the unit.19) If an outside antenna or cable system isconnected to the unit, be sure the antennaor cable system is grounded to providesome protection against voltage surgesand built-up static charges, Section 810 ofthe National Electrical Code, ANSI/NFPA70, provides information with respect toproper grounding of the mast and supportingstructure, grounding of the lead-in wire to anantenna discharge unit, size of groundingconductors, location of antenna dischargeunit, connection to grounding electrodes,and requirements for the groundingelectrode.S3126APORTABLE CART WARNING(symbol provided by RETAC)ANTENNADISCHARGE UNIT(NEC SECTION 810-20)ANTENNA LEAD IN WIREGROUNDING CONDUCTORS(NEC SECTION 810-21)GROUND CLAMPSPOWER SERVICE GROUNDINGELECTRODE SYSTEM(NEC ART 250, PART H)GROUNDCLAMPELECTRIC SERVICEEQUIPMENTNEC-NATIONAL ELECTRICAL CODES2898AEXAMPLE OF ANTENNA GROUNDING AS PER THE NATIONAL ELECTRICAL CODEDownloaded from www.Manualslib.com manuals search engine