Sanyo 42LM4WPN Instruction Manual

Contents

4■ REMOVE TERMINAL COVER AS INDICATED BELOW.■ CONNECT THE DISPLAY UNIT TO AERIAL, VGA. BNC.ANDSCART CONNECTOR AS BELOW.■ TERMINAL COVER MUST BE REPLACED WITH CABLE EXITS ASINDICATED IN THE SKETCH ABOVE.■ Connect the LCD monitor to Aerial, VGA, and Scart connector asrequired.1. Connect the waterproof in-line power connector to the connectorattached to the LCD monitor as shown above.2. Connect the correct power cord of the LCD monitor to a wall outlet.✐ As this product does not have a mains On/Off switch, pleaseensure your mains plug is easily accessible.✐ The LCD monitor is prepared for a mains voltage AC220~240V,50Hz. To completely switch off the mains, or when the LCD moni-tor is not to be used for an extended period of time, it is advisableto disconnect the power cord from the power outlet or disconnectthe mains coupler..3. Warning: To prevent injury, the unit must be securely attached tothe wall in accordance with the installation instructions.1.■ HDMI (High Definition Multimedia Interface)This monitor has an HDMI connector. When connected to the HDMIsource and HDMI is selected using the remote control,There is a shorttime period before the picture appears at a much higher resolution.This connection is located at the back of the monitor next to the aerialsocket.2. Y,Pb,Pr connection (AV2)This LCD monitor has a choice of Y, Pb, Pr or RGB , H/V connectionsYou can connect your DVD player to the Y, Pb, Pr terminals insteadof using a scart lead. This can support high definition in analoguecomponent form. RGB, H/V can be used as a PC input via the BNCterminal.3. PC connectionThis LCD monitor has a PC connector.You can connect a PC to theLCD monitor and use it as a monitor display (see page 9).To switch between TV, AV1, RGB, AV2 RGB H/V or Y, Pb, Pr, AV3,HDMI or PC mode press the TV/ AV switch on your remote controlrepeatedly or press and hold the TV/AV button for a few seconds anda selection menu will appear on screen. Use the e or d buttons toselect the correct mode.4. RS232C IN/OUT: Is a input for external commands to control themonitor (see page 9)Install two "AA" 1.5 volt batteries so that the "+" and "-" marks on thebatteries match the "+" and "-" marks inside the unit into the remotecontrol handset.INSTINSTALLAALLATIONTIONStep : 1 Connections (Essential)AC Mains OutletWARNING! High voltages are used in the operation ofthis set. Refer service to qualified service personnel.Security fixing pointCable entryStep : 2 Remote control battery installationHDMICoaxial aerial INAudio monitorOut AV2 audioINSerial portsIN/ OutServicesAV3 IN/OutBNC AV2 IN/ OutBNCWaterproof in-line connectorWallmountfixingpositionsSecurity fixing pointWARNING!This remotecontrol isnotwaterproofSerialPort-INSerialPort-OUTServiceGB GB