Sanyo DP15647 Owner's Manual

Also see for DP15647: Owner's manual Service manual

1 Install batteries in remote control (2AA, not included).142 Connect Signal to the DTV’s Integrated Analog / Digital75 ohm Antenna Input terminal.GETTING STARTED (REQUIRED INITIAL SETUP)PRECAUTIONSTo ensure safe operation, please observe the followingprecautions:Replace both batteries at the same time. Do not use a newbattery with a used battery.Risk of explosion, if battery is replaced by an incorrect type.Do not expose the Remote Control Unit to moisture or heat.Remove the batteries if the Remote Control will not be used fora month or more. Discharged batteries may leak and damagethe unit.RF ANTENNACABLE ORCABLE BOX OR SATELLITE BOXORANALOG / DIGITAL ANTENNA INTHE TUNER IN THIS DTV CAN RECEIVE:1. Digital and / or Analog Off-Air Signals from an RFantenna.OR2. Analog or ClearQAM cable channels.Note:You must search for ClearQAM channels usingthe “Digital Cable Search” menu option.OR3. The output from a VCR or cable box.Digital signals from a Set-top (STB) Box should bereceived through the Component jacks.This DTV can receive ANY unscrambled RF signalbeing broadcast.(CONTINUED ON NEXT PAGE.)Match the “+” and “–”signs on the batteries withmarks inside the remotecontrol.