Sanyo DP52440 Owner's Manual

5Need help? www.sanyoctv.com 1-800-877-50321 Remove the four (4) screws securing the footstand. CAUTION: Hold the stand firmly as youremove the last screw.2 Use the screws you removed when detachingthe stand to secure the HDTV to a wallmounting kit (not included.)VESA standard interface: 400 x 400Mounting screws measurements:M6 (6mm) Diameter, Length—12mm (maximum)STAND REMOVAL AND WALLMOUNTING (OPTIONAL)Tools Needed: Phillips screwdriverIMPORTANT NOTE: Place HDTV face downon a padded or cushioned flat surface toprotect the screen and finish.Wall mounting of the HDTV must be performedby a skilled person.GETTING STARTEDInstall two (2) “AAA” batteries in the remotecontrol. (Not included)To ensure safe operation, please observe thefollowing precautions:• Replace both batteries at the same time. Do not use anew battery with a used battery.• There’s a risk of explosion if a battery is replaced byan incorrect type.• Do not expose the Remote Control unit to moistureor heat.• Be sure to match the “+” and “–” signs on thebatteries with marks inside the remote control.ANTENNA CONNECTION FOROFF-AIR SIGNALS OR CABLEANTENNACABLEANALOG / DIGITALANTENNA INPOSITIONING THE LCDHDTV• Always use a firm and flat surface whenpositioning your HDTV.• Do not position the unit in a confined area.• Allow adequate space for proper ventilation.BATTERY INSTALLATIONHook up your antenna or your cable service tothe HDTV’s ANT terminal with the use of a 75OHM coaxial cable.NOTE: Keep your indoor antenna at least 3 ft. awayfrom the television set and any other electronicequipment.The tuner in this HDTV can receive:• Digital and Analog off air signals from an antenna• Analog or ClearQAM cable channels from a directCable TV connection.