Sanyo DSR-3009 Manual

Also see for DSR-3009: Instruction manual

Sanyo DSR-3009 Manual Manual pdf 17 page image

16 EnglishMenu Setting ProceduresALARM RECORDINGThis specifies whether alarm recording will be carriedout or not, and sets the recording cycle and recordingconditions when alarm recording is carried out.1 Select an alarm recording mode from the [ALARMRECORDING] menu (default setting: OFF).2 Select the alarm recording method from the[ALARM INTERLEAVE] menu. (Default setting:ONLY)3 Specify the program for recording camera imagesfrom the [PROGRAM GROUP] menu. (See p. 9)4 Select the recording cycle from the [REC RATE]menu.A 60, A 30, A 20, A 15, A 10, 7.5, 6, 5, 4.286, 3.75, 3.333, 3,2.727, 2.308, 2, 1.667, 1.429, 1.25, 1.111, 1, 0.5, 0.333, 0.25,0.2, 0.1, 0.05, 0.033 (Units: FPS)(Default setting: A 30 FPS)5 Set the duration for alarm recording from the[DURATION] menu.1 SEC, 2 SEC, 5 SEC, 10 SEC, 20 SEC, 40 SEC, 1 MIN,2 MIN, 3 MIN, 4 MIN, 5 MIN, 10 MIN, 15 MIN, CC, INDIV.(Default setting: 5 SEC)The alarm recording duration can be set separatelyfor each camera. If you select [INDIV.] from the[DURATION] menu, alarm recording is then carriedout for each camera for the duration of time that hasbeen set using the [ALARM DURATION SET] menuthat is described later on. (See p. 18)• OFF: No alarm recording will be carried out.• ENABLED:Alarm recording is carried out at any time, withoutregard to timer recording (timer settings).• AL-REC ON TIMER:Alarm recording is only carried out during timerrecording.• AL-REC OFF TIMER:Alarm recording is only carried out at times otherthan during timer recording.• OLY AL-RC ON TMR:During the time set by the timer, the only recordingcarried out is alarm recording, not timer recording.• ONLY: Only the camera where the alarm was triggered isrecorded.• SW: The images from the camera where the alarm wastriggered and the images from the camerasspecified by the PROGRAM GROUP setting arerecorded alternately.OFF: No program group is specified and all camera imagesare recorded.P-1: Specifies program No. 1.P-2: Specifies program No. 2.P-3: Specifies program No. 3.P-4: Specifies program No. 4.(Default setting: OFF)