Sanyo DSR-3016P Manual For Remote Operation

Also see for DSR-3009P: Manual Instruction manual

Sanyo DSR-3016P Manual For Remote Operation Manual pdf 11 page image

10 EnglishMenu Setting ProceduresThe hard disk in this unit consists of three independent recording areas, each of which has fiverecording modes.A percentage of the total recording capacity is allocated to each recording area (settings are in unitsof 1%).1 Total capacity displayDisplays the total capacity of the hard disk.2 Capacity display for each recording areaThe recording capacity of each recording area of the digitalvideo recorder’s hard drive is displayed as a percentage ofthe total capacity.3 Recording area resetIf the OVERWRITE setting is “OFF”, recording will stopautomatically when a recording area becomes full. If when[AREA FULL RESET] has been selected, the recordingsthat have been made will be deleted and recording willbegin again from the start of the recording area.4. RECORDING AREA SETRecording area Recording mode NotesNORMAL RECORDINGAREANormal recording Manual Recording is carried out manually using theO button.Timer recording Automatic Recording is carried out automatically withinthe time range specified by the timerrecording setting made using the menuscreen.ALARM RECORDINGAREAAlarm recording Automatic Recording is carried out automatically whenan alarm is detected according to the alarmrecording settings made using the menuscreen.Pre-alarmrecordingAutomatic Images that are around the time that thealarm was detected are recordedautomatically according to the pre-alarmrecording settings made using the menuscreen.This is used as a complementary function toalarm recording.ARCHIVE AREA Copy Manual Copies and saves essential recordings fromanother recording area by using the Mbutton on the operating panel manually.If two hard disks have been installed and thedigital video recorder’s HDD SET function hasbeen used to set mirroring to “ON”, the details forthe disk with the smaller capacity will bedisplayed.The capacities of the recording areas cannot beset and changed from a connected computer.If the recording capacity for the normal recordingarea and the alarm recording area have been setto 0% and if the OVERWRITE setting is “ON”,there is no need to use the reset function, and sothe AREA FULL RESET button will not appear onthe screen at such times.123