Sanyo DSR-M800 Instruction Manual

Contents

Sanyo DSR-M800 Instruction Manual Manual pdf 11 page image

103 INSTALLATION AND CONNECTIONSINTRODUCTION SETTINGS OTHER OTHER OTHER OTHERz Connect the cable of the wired remote control (VA-RMN01) (sold separately) to the remote control inputterminals (among the control terminals).Cut the plug off the cord, and connect the red wire to“REMOTE” and the bare wire to “C”.(1) Push in the lock pin with a flat-blade screwdriver.(2) Insert the cable.(3) Pull out the lock pin with a flat-blade screwdriver. Thecable is now fixed in place.The VA-SW800 application software (sold separately) letsyou control the digital video recorder, and monitor liveimages, recorded images and audio through a network.1 When you have finished making all theother connections, insert the powerplug into the wall outlet.There is no power switch. All the display indicators flash forapproximately 30 seconds, then the POWER indicatorlights. The monitor screen displays the camera image.z When turning the power ON for the first time"PLEASE SET THE CLOCK" is displayed on the monitorscreen. Follow the steps on page 12 to set the clock.z If the clock is alreadysetThe operation displayarea is displayed.z If the POWER indicator flashesThe digital video recorder has a self-check function thatindicates problems. If there is a problem at power ON orduring operation, the type of problem is indicated by howrapidly the POWER indicator flashes. Contact a SanyoAuthorized Service Center if the POWER indicator flashes.4 flashes per second:The disk is checked automatically at power ON. If a harddisk problem is found, the POWER indicator flashes,and the hard disk must be replaced or reformatted. If youneed to save images stored on the disk, contact a SanyoAuthorized Service Center.1 flash per second:Fan problemz If you disconnect the power cableDon’t move the digital video recorder for 30 secondsafter power OFF.The disk in the hard disk drive briefly keeps spinningafter power OFF due to inertia, during which time thehead is unstable. At this time, the disk is sensitive toshocks or vibrations, so avoid even light shocks.Connecting cables to the control andalarm terminalsConnecting to a networkRS485 REMOTEA B C CBare wireRed wireWhitewireVA-RMN01CableFlat-blade screwdriverConnecting the power cordAUDIOAC INADDRESSADDRESSAUTO/MANUALRS485RS485 REMOTE CLOCK NONALARM INALARM RESETALARM OUTWARNING OUTALLRESETFULL OUTADJ REC OUTA B C C C CIN OUTTERMINATE1 2 3 4 5 6 7 8LAN VIDEOMIC ININ OUT IN OUT TV SYSTEMNTSCPALPower cableOperating displaye_dsr_m800.book Page 10 Friday, January 31, 2003 5:45 PM