Sanyo FXD-MP690 Operating Instructions Manual
Also see for FXD-MP690: Service manual
                      | |
Contents
| 
TROUBLE SHOOTINGSometimes a simple operational error or a mistake in the wiring can appear to be a problem withthe unit. Before having the unit serviced, refer to the troubleshooting chart below.Symptom Cause SolutionThe volume control is turned down. Turn up the volume control.The compact discdoes not play wheninserted into theunit.The power connections are not wiredcorrectly.Check the +12V and groundconnections.The vehicle ignition is switched off. Switch the ignition to the “ON”or “ACC” position.No power.The fuse is blown. Replace the fuse with another 15Afuse.The unit does notwork properly(Eject, Load, Play)The microcomputer has been affectedby electrical noise.Press RESET button.The road surface is rough. Wait for the road surface toimprove before playing a disc.The unit is not mounted securely. Install the unit securely. Be sure touse the rear strap if the vehicledoes not provide support for therear of the unit. (See page 20)The sound from theCD player skips.The disc is defective. Try another disc.If it plays properly, the first discmay be defective.The disc is dirty. Clean the disc as explained onpage 3.No radio reception. The antenna cable is not connected. Insert the antenna cable firmly intothe antenna jack on the unit.The radio does notstop on anystations whenautomatic tuning isused.The signals are weak. Select a station using manualtuning.18 |
Related manuals for Sanyo FXD-MP690
This manual is suitable for:
manualsdatabase
Your AI-powered manual search engine