22 Need help? Visit our Web site at www.sanyoctv.com or Call 1-800-877-5032Problem Check these Conditions Try these Solutions Page No.Cannot select orscan somechannels. Channel may be removed frommemory. Check antenna connections. No digital signal being broadcast. Signals are weak. V-Guide is set to block programming. Select CH. Scan Memory and manuallyadd channels or start CH. (channel)search. Turn Antenna or install signal booster. Set V-Guide to “Allow All” or press theRESET key to clear all settings andrestart channel search.1718 ~ 1913Remote Controlwill not work TV. Check batteries. Check to see if TV is plugged in. Replace batteries, two “AAA.” Aim remote control at front of TV.6,12 ~ 13Cabinet makespopping sound. This is a normal condition duringwarm-up and cool down of the plasticcabinet parts.Because of the Quality we build into our product,very few problems are actual DTV defects. Most prob-lems only involve simple hookup or setup changes thatcan be solved by the customer. Please check the chartbelow and try the solutions listed for your problem. If theproblem still persists, before returning your DTV,please visit our website at www.sanyoctv.com or callus toll free at 1.800.877.5032.We can Help!HELPFUL HINTS (Problems/Solutions) ContinuedCARE AND CLEANINGCLEANING THE CABINETThe surface of the cabinet can be damaged if not properly maintained. Many commonhousehold aerosol sprays, cleaning agents, solvents, and polishes will cause permanentdamage to the fine surface.1. Unplug the power cord before cleaning the television.2.. Clean the cabinet with a soft dry cloth.NOTE: Never spray liquids on the screen because they can run down and drip ontothe chassis. This may cause component failure not covered under Warranty. ASD I G I T A LD I G I T A LDOLBYDOLBYDIGITAL TUNERINTEGRATEDINTEGRATEDPOWERCH VOL